DTC P1514

Circuit Description

The powertrain control module (PCM) uses the throttle position (TP), barometric pressure (BARO), intake air temperature (IAT), and engine RPM in order to calculate the predicted mass airflow rate. The PCM compares the predicted mass air flow (MAF) value to the actual mass airflow value and the speed density calculation in order to verify the proper throttle operation.

Conditions for Running the DTC

• DTCs P0601, P0602, P0604, P0606, P1515, P1516, P1517, or P1518 are not set.
• DTCs P1120, P1220 and P1221 are not set at the same time or DTCs P1120 and P1220 are not set at the same time.
• The engine operates longer than 1 second.
• The engine speed is greater than 500 RPM.

Conditions for Setting the DTC

• The PCM detects that the difference between the actual airflow (MAF) and the speed density calculated airflow is greater than expected.
• All of the above conditions met for less than 1 second.

Action Taken When the DTC Sets

• The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
• The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame and/or the Failure Records.
• The control module commands the throttle actuator control (TAC) system to operate in the Reduced Engine Power mode. OR
• Under certain conditions the control module commands the engine OFF.
• The message center displays Reduced Engine Power.

Conditions for Clearing the MIL/DTC

• The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
• A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
• A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
• Clear the MIL and the DTC with a scan tool.

Diagnostic Aids

• Inspect the throttle blade for being broken, bent, or missing.
• Inspect the TP sensor for proper installation. A sensor that is mis-aligned could set this DTC.
• Inspect the TAC module connectors for signs of water intrusion. When water intrusion occurs, multiple DTCs could be set with no DTC circuit or component conditions found during diagnostic testing.
• Physically and visually inspect the throttle body assembly, and correct any problems that you observe. Manually move the throttle blade from closed to wide open throttle (WOT). You should not need to use excessive force. The throttle blade should move smoothly through the full range and should return to a slightly open position on its own.
• When the TAC module detects a condition within the TAC system, more than 1 TAC system related DTC may set. This is due to the many redundant tests that run continuously on this system. Locating and repairing 1 individual condition may correct more than 1 DTC. Disconnecting components during testing may set additional DTCs. Keep this in mind when reviewing the stored information, Capture info.
• For an Intermittent condition, refer to Intermittent Conditions .

Test Description

The number below refers to the step number on the diagnostic table.